Print

Instruction for Dermaflage Use

Kit set included:

applicator tool pad
Applicators (2 of same color) Application Tools Texture Pad
Silicone Fillers, 11 color tones available Depending on the scar size and shape, Dermaflage Silicone can be applied by using the spatula, directly from the mixing tip, by hand, or for a small ice pick scar, a small Q-tip. Flatten Dermaflage as well as impart skin pore shapes onto the Dermaflage Silicone surface. This will decrease shine and makes Dermaflage looks like normal skin.
Plus Makeup Bag

front5

Accessories:

mixing-tips Dermaflage Mixing Tips
Mixing tips can fully blend the mixture together.
Control volume, reduce waste.
Small tip can easy fill in fine depressed areas like acne scars.
Make the procedure more simple and tidy.
The old mixing tip need to be discarded once used, as the silicone inside will have dried. A new one will be required. However, the old tip can be kept on before next use to prevent drying of the product.

front5

3 Simple Filling Steps:


1. Mixing tip is screwed on and Dermaflage is squeezed out

Mixing tip enable the two materials of Dermaflage to mix thoroughly. Once mixed, they will set in around 2-5 minutes in room temperature. Align the cap grooves correctly then screw on.

The mixing tip cannot be reused once used because the Dermaflage inside will have dried. However leave it on until next use.
change tips2 tips time tips reuse
 
mixing3 mixing2
Click to Enlarge Click to Enlarge

2. Dermaflage is applied via the spatula, directly through the mixing tip, by hand or by a small Q-tip

Depending on the scar size and shape, Dermaflage Silicone can be applied by using the spatula, directly from the mixing tip, by hand, or for a small ice pick scar, a small Q-tip.

use of toolDo not dap or pat the silicone.

d3Blend the silicone from the center out slowly, smoothing out the edge with the fingers if required.

The correct amount is required as too much will cause bulging while too little will not fill up the scar completely. If in doubt, use less rather than more. You have to work quickly as Dermaflage Silicone dries in 2 to 5 minutes depending on room temperature.

Note:  

To prolong the time for Dermaflage silicone to set, refrigeration to lower the temperature can be done.
The time of refrigeration depends very much on the original room temperature and the temperature inside the fridge where you are going to put the Silicone, where there will be a temperature difference between different fridges, as well as temperature difference between the door of the fridge and deep inside the fridge.
The refrigeration time can range from few minutes in cold areas to an hour in tropical countries. Prolong refrigeration may destroy the Silicone material.

Please note that a longer hardening time will also means a longer procedure time.
coldlogo

The two Silicone must be thoroughly mixed for the setting reaction to occur, thus the mixing tip is advised. Mixing by hand is not recommended unless after a while you are very skilled in its use as well as refrigeration has been done beforehand. Mixing by hand can also be considered if you have a very small area to cover.

Large area need to be covered in clustersYou have to work quickly as Dermaflage Silicone dries in 2 to 5 minutes depending on room temperature.


d1Click to Enlarge d5Click to Enlarge d6
Click to Enlarge
Do not dap or pat the silicone Using too much Using less than enough
  The correct amount is required as too much will cause bulging while too little will not fill up the scar completely. If in doubt, use less rather than more.

3. Use texture pad
The texture pad will flatten Dermaflage as well as impart skin pore shapes onto the Dermaflage Silicone surface. This will decrease shine and makes Dermaflage looks like normal skin. texture pad Click to Enlarge
Note:

The texture pad will flatten Dermaflage as well as impart skin pore shapes onto the Dermaflage Silicone surface. This will decrease shine and makes Dermaflage looks like normal skin.
The Pad can be cut for smaller sizes as well as awkward angles.
Applied the pad till Dermaflage dries. Depending on room temperature this could range from 2 to 5 minutes.
Do not press too hard.
d7Click to Enlarge d2Click to Enlarge
If in doubt, see if the Silicone on the mixing tip has dried before you remove the texture pad. That way you will know the Silicone on your skin has dried. To not remove the pad before it dries (no peeking!)
front5

Color:

colorhead2
“Golden fair”, “medium”, “fair” and “light”,are recommended in Asia or fair skinned Caucasians
 

front5

Make up: 

coverderm classic p dermacolor camo creme p
Mineral non oil based makeup can be used before application of Dermaflage. As Dermaflage is semi-transparent, the underlying color will get through naturally.

In case the color is not an exact match and all else fails, cream based camouflage cosmetics of matching skin color such as Coverderm Classic or Dermacolor Camouflage Cream can be used on top.

 

Online Shop Category

Your Cart

 x 
Cart empty

Coverderm

 


Dermaflage

 


Dermacolor